07-21-2003 05:43 AM - edited 03-09-2019 04:07 AM
Security monitor, 1.2, does not permit iniation of a block from the event viewer. Pop-up states that currently only version 3 sensors are supported. Is manual blocking support planned for a future release? If so, when?
Thanks
07-25-2003 07:20 AM
Hi, I was wondering if you tried blocking the signature from IDSMC instead? That would be equally effective.
07-25-2003 07:51 AM
Yes, I can configure blocking in the MC but also want to preserve the feature of blocking on the fly.
08-08-2003 01:47 PM
I know it has been discussed for possible inclusion in a future version, but I can't say whether or not it was agreed to of for which future version.
In the meantime, dropping on the fly has to be done through the IDM interface of the sensor.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide