i'm trying to troubleshoot one of our site today and can't seem to issue the show dsl interface command on a 1841 router. could someone advise if the same command is used for SHDSL or am i running with an IOS bug? thanks in advance!
% Unrecognized command
Cisco IOS Software, 1841 Software (C1841-BROADBAND-M), Version 12.4(15)T7, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2008 by Cisco Systems, Inc.
Compiled Wed 13-Aug-08 15:42 by prod_rel_team
NAME: "chassis", DESCR: "1841 chassis"
PID: CISCO1841 , VID: V05 , SN: FHK13212639
NAME: "WIC/HWIC 0", DESCR: "WAN Interface Card - ATM (With multi line G.SHDSL module)"
PID: WIC-1SHDSL-V3 , VID: V02 , SN: FOC132041KD
Solved! Go to Solution.
guess it was there all along. maybe i've got used to the show dsl int on our 800s.
#sh controllers dsl
DSL 0/0/0 controller UP
Globespan xDSL controller chipset
Line Mode: Four Wire Enhanced
DSL mode: Trained with SHDSL Annex B
Frame mode: Utopia
Configured Line rate: 4608Kbps
Line Re-activated 0 times after system bootup
LOSW Defect alarm: ACTIVE
CRC per second alarm: ACTIVE
Line termination: CPE
FPGA Revision: 0xB3