1356
Views
0
Helpful
1
Replies
Adding a Serial Interface in IOSV Router
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-04-2019 01:24 PM
I tried creating a new lab with iosv routers. I wanted to simulate Multilinks but I dont see serial interface available on the device. Is there a way to add WICs with 2 or more serial interfaces? I am new to this tool. Thanks..
Labels:
- Labels:
-
WAN
1 Reply 1

Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-05-2019 12:05 PM
Hello,
IOSv images (which are the same images as those used in VIRL) do not support serial interfaces, unfortunately. Packet Tracer does have serial interfaces (but is is obviously very limited)...
