Does anyone know why the bandwidth statement on the subinterface would be ignored unless its applied to the main interface? In a head-end setup i may have additional subs and I would think the bandwitch statement on the main int should reflect the actual bandwidth while the subs woudl reflect their individual allocation.. Config:
policy-map main-policy class voice-class-map bandwidth percent 20 class video-class-map bandwidth percent 30 class management-class-map bandwidth percent 5 class critical-class-map bandwidth percent 25 queue-limit 1024 packets random-detect class class-default bandwidth percent 5 queue-limit 1024 packets random-detect policy-map traffic-shape-policy class class-default shape average percent 90 service-policy main-policy ! int gi0/0 desc WAN speed 100 duplex full bandwidth 50000 ! int gi0/0.100 encap dot1q 100 ip 22.214.171.124 255.255.255.0 service-policy out traffic-shape-policy bandwidth 50000
To configure bandwidth to be used as a reference for calculating rates of quality of service (QoS) percent configurations on a physical or logical interface, use the bandwidth qos-reference command in interface configuration or subinterface configuration mode.
Cisco Champion Radio · S7|E30 Taming Your AI/ ML Workloads with Kubeflow
As organizations increasingly introduce machine learning (ML) capabilities to their existing products, their artificial intelligence (AI) projects and operations complexity g...
Cisco IOS-XE 17.3.1 – Catalyst Switching Updates
Table of Contents
Hardware Additions since IOS-XE 17.2.1
Key Summary Features
Platform and Infra Features
High Availability Features
Routing / MPLS / VPN Features
Hi Everyone,I have 2 queries1. After we configure the IPSec VPN in a Cisco Router, how do we identify and check that the traffic is flowing through the tunnel? Are there any commands and ways to find it out?2. What are some of t...