We installed the DS3 connection and the ISP provides only 20 MB bandwidth, and we run QoS modular. I was under impression that the command "bandwidth" is for QoS setup, and the command " dsu bandwidth" is layer1 setup. I have questions about the difference " bandwidth" and " dsu bandwidth". Did I configure right? Please advise.
The interface "bandwidth" command like you have configured does not apply to QoS. It is for routing protocols like EIGRP, etc. There is also a "bandwidth" command you use under a policy-map which is used for QoS.
QoS example using bandwidth:
bandwidth percent 30
Additionally you would need to define the class-map and apply the policy to an interface. This older document describes the use of the bandwidth command in QoS.
GoalDocumentationDefineAdd Device to Smart AccountSync Smart Account via vManage1.1 VNF package for vBranchDesignDeployOperate
To successfully provision a ENCS device in remote site with internet connection.
Minimum software relea...
はじめに確認方法Version による Application name の変更について備考参考情報 はじめに本ドキュメントでは Cisco SD-WAN における Policy 上で設定可能な Application を確認する方法について記載しています。 確認方法サポートされている Application name についてはご使用されている vManage へ API を呼び出して確認することが可能です。https://<IP or FQDN>/...
DMVPN (Dynamic Multipoint VPN) Introduced by Cisco in late 2000 is a routing technology you can use to build a VPN network with multiple sites (spokes) without having to statically configure all devices. It’s a “hub and spoke” network, where the spok...
On 24th August 2021, Cisco announced the latest IOS XE release - Cisco IOS XE Bengaluru 17.6.1a
IOS XE 17.6.1a unlocks various routing features and enhancements comprehensively covering different technology segments such as voice, security,...
DMVPN (Dynamic Multipoint VPN) Introduced by Cisco in late 2000 is a routing technology you can use to build a VPN network with multiple sites (spokes) without having to statically configure all devices. It’s a “hub and spoke” network, where th...