Command to check supervisor crc error threshold is needed!

[michael.ledzbor]

Hi Colleagues,

We have seen the following message on a  CISCO 7609-S (12.2(33)SRD3):

%FABRIC_INTF_ASIC-4-FABRICCRCERRS: Fabric ASIC 0: 239 Fabric CRC error events in 100ms period

Explanation (Output Interpreter): The Switch Fabric interface Fabric interface encountered more crc

error    events than the Supervisor crc error threshold allows.

We would like to check the current crc error counter and crc error threshold on the supervisor.

Does anybody know which commands have to be issued to get this information?

Many thanks in advance!

BR

Mike

[John Blakley]

Try here:

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801c6652.shtml#truncated

If you're using truncated, it looks like the default threshold is 2.

You may also want to look at Switch Fabric Module Redundancy in the same document.

John

[Ivan Krimmel]

Hi Mike,

please take off the following outputs several times with a slight interval between them:

show fabric channel-counters

show fabric errors

show fabric drops

remote command switch sh fabric errors

it might be a one time occurence(most likely).

Cheers,

Ivan.