I am stepping through some base hardening on an ISR4451-X and I would like to use Control Plan Protection, however, when I issue the commands the host subinterface is all I get. There is no cef-exception or transit subinterface. Additionally, when I do try to apply a policy map to the host subint I don't even get the option to do so. It is looking for a management interface assignment. The specs said the hardware support CPPr but are there caveats to when this would even apply?
ROUTER(config)#control-plane host ?
Control Plane host configuration commands:
exit Exit from control-plane host configuration mode
management-interface Configure interface for receiving network management
no Negate or set default values of a command
This is a new product launch - Catalyst 8000 Edge Platforms Family Overview. We will go over the series Catalyst Cellular Gateway in great detail.
Speaker: David Roten, Technical Marketing Engineer at Cisco
David is a Technical Marketing Engineer for...
“Use Serviceability Features to Troubleshoot your Cat9K as a Cisco TAC Engineer”
This event took place on Tuesday 1st, December 2020 at 10hrs PDT
This event provides an introduction to the main Cat9K serviceability features. Serviceability is the pr...
Enhanced Interior Gateway Routing ProtocolEnhanced Interior Gateway Routing Protocol (EIGRP) is an interior gateway protocol suited for many diffrent topologies and media. In a well designed network, EIGRP scales well and provides extremely quick converge...