guyshave 3750 switch and there are couple of vlans.....i dont want to run the instance on all vlans....so i have decided that i will run passive intreface default command....now my lan link is layer three and i want to run eigrp on that so the command shd be as under???
no passive interface default interface gig1/0/10
no passive interface default interface gig1/0/22
(as i have 2 conections) and want to have two neibours
If it was me I would just have the two network statements that cover the two interfaces. Not sure but I think you can set on the interfaces that you want to route also. Inter g1/0/1 then ip router EIGRP AS instead of the network statements. It might be a nexus thing though.
In this special edition of the Insider Series, we hear from Cisco partners who have taken steps to be more eco-friendly and sustainable. We hear what inspires ASHRAE, Southwire, Igor, and NTT to create a workplace that is centered around people and how th...
We know that the Type-1 LSA describes the link type connected to the router, the neighbor router and the subnet number.In this topology, assume we dont have a Type-2 LSA, so each router will create its own Type-1 LSA, the Type-1 LSA will describe the neig...
Here are some commonly asked questions and answers to help with your adoption of Cisco DNA Center Wireless. Subscribe to this post to stay up-to-date with the latest Q&A and recommended Ask the Experts (ATXs) sessions to attend.
Q. I have a Cisco Appl...
Why IETF changed and inverted OSPF Type-7 LSA VS Type-5 LSA election In RFC 3101 compared to OLD RFC 1587?Many people learns that the Type-7 LSA and Type-5 election (ON Versus OE routes) depends on RFC 3101 for NSSA published in 2003 and RFC 1587 for NSSA...