Hello,
I have enabled "ip device tracking" on my switches. However, I have a switch that doesn't show any info!! It works on all other switches.
What exactly does this output means;
NY-EF0.1-01# sh ip dev trac all
IP Device Tracking = Enabled
IP Device Tracking Probe Count = 3
IP Device Tracking Probe Interval = 30
---------------------------------------------------------------------
IP Address MAC Address Vlan Interface STATE
---------------------------------------------------------------------
172.17.20.166 5c26.0a4b.b179 320 GigabitEthernet2/0/47 INACTIVE
192.168.16.24 0021.703a.9316 666 GigabitEthernet1/0/19 ACTIVE
Total number interfaces enabled: 3
Enabled interfaces:
Gi1/0/3, Gi1/0/19, Gi2/0/47
The "Enabled interfaces" - I thought IP device tracking was enabled for all interfaces once the command "ip device tracking" was entered globally? The config on all ports are the same, still I only get device info from a few, and according to the switch it's only enabled on 3 interfaces;
switchport access vlan 320
switchport mode access
authentication control-direction in
authentication event fail action authorize vlan 666
authentication event server dead action authorize vlan 320
authentication event no-response action authorize vlan 666
authentication event server alive action reinitialize
authentication port-control auto
snmp trap mac-notification change added
snmp trap mac-notification change removed
dot1x pae authenticator
dot1x timeout quiet-period 20
dot1x timeout tx-period 10
storm-control broadcast level 5.00
storm-control multicast level 30.00
no cdp enable
no cdp tlv server-location
no cdp tlv app
spanning-tree portfast
spanning-tree bpduguard enable
spanning-tree guard root
What do to people?
