12-06-2012 05:07 AM - edited 03-04-2019 06:20 PM
Hello Community,
I've set up my GNS3 router to log to console and terminal monitor at debug level, see below. However, when I can't see any logs. Can someone shed some light on the reason why?
Cheers
Carlton
R4#show logg
Syslog logging: enabled (11 messages dropped, 0 messages rate-limited,
0 flushes, 0 overruns, xml disabled, filtering disabled)
Console logging: level debugging, 67 messages logged, xml disabled,
filtering disabled
Monitor logging: level debugging, 0 messages logged, xml disabled,
filtering disabled
Buffer logging: disabled, xml disabled,
filtering disabled
Logging Exception size (4096 bytes)
Count and timestamp logging messages: disabled
No active filter modules.
Trap logging: level informational, 82 message lines logged
Logging to 192.168.1.1(global) (udp port 514, audit disabled, link up), 82 message lines logged, xml disabled,
filtering disabled
R4#
Solved! Go to Solution.
12-06-2012 06:01 AM
Add the logging buffered command. Example below
logging buffered 30000 informational
==========================
http://www.rConfig.com
A free, open source network device configuration management tool, customizable to your needs!
12-06-2012 06:01 AM
Add the logging buffered command. Example below
logging buffered 30000 informational
==========================
http://www.rConfig.com
A free, open source network device configuration management tool, customizable to your needs!
12-06-2012 06:24 AM
Stephen
Thanks
Carlton
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide