Need help with switch config that has multiple egress points
I have a 3750G that has multiple egress points. Our default route sends all traffic out exit A. How can I configure other types of traffic to use exit B and exit C? I am using route commands but I rather use a different solution. The route commands dont work well for web traffic unless I know the IP addresses of the web site. Any help and suggestions would be great.
Re: Need help with switch config that has multiple egress points
You can do Policy based routing (PBR). With PBR you can route traffic based on source, destination, protocol(http, ftp, etc.), incoming interface.
Here is a quick overview:
1) You need to enable PBR by running command "sdm perefer routing" which enables the template. 2) Then you need to define an extended ACL matching your traffic based on source/destination/protocol. 3) Create a route map and match this ACL and set nexthop through your desired egress point. 4) Apply the route map to the incoming intreface
This will take preference over your routing table. In case, PBR fails it fallsback to normal routing table.
Currently when changing the Authentication Template under the Onboarding section, there is no choice but to remove SGTs, VNs and IP Pools which clearly disrupt existing services.
Hitless Authentication was introduced in...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefix...
Let's say we have two routers configured as RP candidates for auto-RP: R1 - "advertising" its loopback0 interface IP address 188.8.131.52 as the RP for these groups:184.108.40.206/32220.127.116.11/3218.104.22.168/2422.214.171.124/16 R2 - "advertising" its loopback0 int...
hi,i just performed an IOS upgrade and got a report that admin can't create L2 VLANs.i noticed the 'vtp primary force' and 'vtp primary mst' was applied to one of the core switch and perhaps got lost after the upgrade.how to keep the VTP primary persisten...