I'm trying to do some redistribution of bgp into eigrp in gns3.
This works fine, redistributing bgp into eigrp, I can see all my routes. router eigrp 1 network 10.2.2.0 0.0.0.255 redistribute bgp 65501 metric 100 1 255 1 1500
When I add the route-map to the redistribute statement, all eigrp routes are filtered out, not just the one in the prefix list. I don't see what I'm doing wrong, if you can point me to some good links that I can read up on, that would be great. ! route-map BGP2EIGRP deny 10 match ip address prefix-list novoip_plist ! route-map BGP2EIGRP permit 20
ip prefix-list novoip_plist seq 50 deny 10.10.10.0/24
The 2020 IT Blog Awards, hosted by Cisco, is now open for submissions through October 16. Submit your blog, vlog or podcast today. For more information, including category details, the process, past winners and FAQs, check out: https://www.cisco...
Hello,We have a pair of N3K-3064PQ-10GX and one of them acting as backup and we want to migrate from VyOS to it, we want to add 500x interface vlan and each interface vlan has its own ip/prefixes (for example /30 /29 ...) and we ahve 6-8x BGP session with...
We live in an age that is both thrilling and evolving substantially. A new trend/technology is always on rise even before the preceding has been used to its fullest potential. Although the concepts of digital transformation may seem over discussed, ...
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.