Hello I have configured the bandwidth percent remaining command on my network i was wondering if there is a way to test it. Or if anyone spots if i made a mistake. below is the config
IP's changed
!
class-map match-all 25vlan
match access-group 106
class-map match-all 20vlan
match access-group 105
!
!
policy-map rome_conference
class 20vlan
bandwidth remaining percent 50
class 25vlan
bandwidth remaining percent 50
!
!
interface FastEthernet0/0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-FE 0/0$$FW_INSIDE$
bandwidth 3088
ip address 192.168.3.1 255.255.255.0
no ip redirects
no ip unreachables
no ip proxy-arp
ip route-cache flow
duplex auto
speed auto
no mop enabled
service-policy output rome_conference
!
interface FastEthernet0/0.1
description $FW_INSIDE$
encapsulation dot1Q 20
ip address XX.XX.66.1 255.255.255.128
ip access-group 100 in
no ip redirects
no ip unreachables
no ip proxy-arp
ip nbar protocol-discovery
ip virtual-reassembly
no snmp trap link-status
!
interface FastEthernet0/0.2
description $FW_INSIDE$
encapsulation dot1Q 25
ip address 192.168.0.1 255.255.255.0
ip access-group 101 in
no ip redirects
no ip unreachables
no ip proxy-arp
ip nat inside
ip virtual-reassembly
no snmp trap link-status
!
access-list 105 permit ip any XX.XX.66.0 0.0.0.127
access-list 106 permit ip any 192.168.0.0 0.0.0.255
