WAAS Installation not working

[carmenanderson]

Having problems activating embedded WAAS in a 2901 router.

interface Embedded-Service-Engine0/0
 description WAAS_Module_Interface
 ip address 192.168.1.13 255.255.255.252
 ip wccp redirect exclude in
 service-module ip default-gateway 192.168.1.13
 service-module ip address 192.168.1.14 255.255.255.252
 no shutdown
 no keepalive
end

n1-router-001#sh inter Embedded-Service-Engine0/0
Embedded-Service-Engine0/0 is initializing, line protocol is down
  Hardware is Embedded Service Engine, address is 0000.0000.0000 (bia 0000.0000.0000)
  Description: WAA_Module_Interface

n1-router-001#service-module  Embedded-Service-Engine0/0 status
Service Module is Cisco Embedded-Service-Engine0/0
Service Module supports session via TTY line 2
Service Module heartbeat-reset is enabled
Embedded Service Engine boot state is RESET
No install/uninstall in progress

n1-router-001#service-module  Embedded-Service-Engine0/0 statistics

Module Reset Statistics:
  CLI reset count = 0
  CLI reload count = 0
  Registration request timeout reset count = 0
  Error recovery timeout reset count = 0
  Module registration count = 0

[Vinit Jain]

I dont this the embedded service engine is supported on Cisco 2901. Please refer to the CCO:

http://www.cisco.com/c/en/us/td/docs/interfaces_modules/services_modules/cimce/1-0/configuration/guide/CIMCe.html#wp1104930

Hope this answers,

Regards

Vinit

[Vinit Jain]

Also, i believe the default RAM required for Embedded Service Engine is 1Gig and the default RAM on ISRG2 should be around 512 Mb.

Could you please confirm on the memory as well.

Thanks

[carmenanderson]

This is waas express not with the service module.