The Anyconnect Essentials is a license that allows you to connect up to your 'Total VPN Peers" platform limit with AnyConnect. Without an AnyConnect Essentials license, you are limited to the 'SSLVPN Peers' limit on your device. With the Anyconnect Essentials License, you can only use Anyconnect for SSL - other features such as CSD (Cisco Secure Desktop) and using the SSLVPN portal page for anything other than launching AnyConnect are restricted.
You can see your limits for the various licensing by issuing the 'show version' command on your ASA.
2) Is there a separate AnyConnect Essentials client needed on the ASA if I already have Anyconnect installed?
A: No. Anyconnect Essentials is just a license - there is no separate client needed.
3) How do I enable the AnyConnect Essentials license?
Instructions for installing the license key will be included when you get the license. Once you've installed the key and rebooted, running the 'show version' command should indicate that the license is enabled. You should see output similar ot the following:
AnyConnect Essentials : Enabled perpetual
Once that is there, you turn on the license by doing the following:
4) So I can't use the portal page at all with AnyConnect essentials?
A: The portal page exists, but once logging in you will immediately launch AnyConnect. Other features (bookmarks, java plug-ins, etc) will not be available.
5) What version of ASA code do I need for AnyConnect Essentials?
A: ASA 8.2 and above support AnyConnect Essentials.
6) Exactly which features are supported by AnyConnect Essentials vs Anyconnect Premium Licensing?
I was reviewing the configuration of a new VPN tunnel from with the FMC and made a change that I do not want to deploy to the FTD. How do I revert this change on the FMC that the working configuration? Seems like this should be a simple thing, ...
We are running ASA 9.12 software on an FTD 2120 and we need to backup the configuration file via the management interface using Kiwi CatTools nightly. After each attempt "Did not receive command prompt after connecting via SSH" is displayed in Kiwi when u...
Greetings, We just deployed AnyConnect 4.8.00175 to our MAC users in anticipation of macOS Catalina 10.15 (upgrading from AnyConnect 4.5.05030). Cisco AnyConnect 4.8.00175 is the first version that officially supports operation on macOS Catalina and ...
I've read posts and documentation about the distributed deployment. Primary PAN and MnT in onc DC, Secondary PAN and MnT in another DC. My understanding is that this requires at least 1 heath check node. Has anyone one done this in ACI wi...
Hi,I'm trying to register the secondary ACS to the primary (log collector). When adding from secondary "Register to Primary" I'm getting the Connection timed out message (see below).I have confirmed they have reachability to each other and proper IP ...