Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up AnyConnect on a ASA that has two ISP connected on different public interfaces. I am using a 5515X with the 8.6 code. At the current time I am using a self sign certificate. I can get AnyConnect to work on one of the public interfac...
I am doing some testing with the Telepresence Jabber client to see how useful it would be for my firm's clients and possible use internally.I can connect from inside the network to outside the network usually without a problem. When I usually start ...
I am doing some testing with Jabber to see how useful it would be for my firm's clients and possible use internally.I can connect from inside the network to outside the network usually without a problem. When I usually start seeing a problem is conn...
I am working on setting up AnyConnect from scratch. I have been using DOC ID 99756 as a base to work from.I am using an ASA that currently doesnt have NAT in place and at this point, will only be used as a VPN Termination device.I can connect and au...
I am trying to setup AnyConnect on a ASA 8.2.5 from scratch. I can get connected and dont see any errors. Not able to ping the inside interface or the device I have attached to the inside interface. From the ASA, I can ping the device attached to ...
Here is the config from the router that I am trying to connect to on the inside interface of the router - interface GigabitEthernet0/0ip address 10.34.50.90 255.255.255.0duplex autospeed auto!interface GigabitEthernet0/1ip address 10.34.110.2 255.255...
redid the management-access line just to make sure. Here are the results - DMZ-ASA# sh capture capin4 packets captured1: 13:40:15.817477 10.34.250.1 > 10.34.110.2: icmp: echo request 2: 13:40:20.412759 10.34.250.1 > 10.34.110.2: icmp: echo request 3...
I put the management-access inside back into my configuration from what you sent but that is all that I put back. Here is the output of what you asked me to run. I dont see it declining any traffic. I was trying to ping 10.34.110.2.DMZ-ASA# sh log...
Just tried the config, I can get to the outside world while the anyconnect client is connected which is what I dont want the user to be able to do. Still unable to get to any resources on the inside of the firewall while coming from the outside.Whil...
