BlueCoat PacketShaper and Cisco ACS v5....

2756

Views

Helpful

Comments

edited on: ‎03-08-2019 ‎06:44 PM

Latest Contents

How To Send FRAMED-IP-ADDRESS from ASA to ISE for VPN'd User

Created by Evanjrosado on 09-21-2019 08:56 PM

I'm reaching out to see if anyone knows how to configure a Cisco ASA to send RADIUS attribute 8 FRAMED-IP-ADDRESS to ISE. I would like this communicated to ISE so that it receives a VPN'd users IP address. Thanks.

NAT in FTD

Created by fatalXerror on 09-21-2019 08:23 AM

Hi Guys, just want to double check with you. In FTD, I have 2 subnet and if I need to have intervlan for those 2 VLAN, do I still need to configure an identity NAT or any NAT?My target is doing intervlan routing between the 2 VLAN without any IP change.th... view more

DVTI virtual template not coming up

Created by umeshunited on 09-21-2019 03:55 AM

Hi,I set up DVTI in EVE with 2 routers. HUB------SPOKE.Virtual-template is not showing up/down. Instead of up/up.Checked Phase1 and Phase2 parameters but not sure where I made a mistake.Attached diagram and configuration.Please take a look.

Firepower (1010) Topology

Created by Bob33 on 09-21-2019 03:51 AM

The installation manual suggests to connect the firewall in between the modem and the router. In my case the ISP has combined that in one device. Do I now connect it before the modem/router or after?

Cisco ISE 2.6 sessions not clearing after accounting STOP

Created by vigguviggu on 09-21-2019 01:39 AM

I tested using both Cisco ISE 2.4 (patch 9) and Cisco ISE 2.6 (patch 1). I have a user who successfully authenticated via RADIUS against ISE. Under ISE, Operations > Live Logs (and Live sessions), I see the user authenticated. After the accounting requ... view more

CreatePlease to create content

BlueCoat PacketShaper and Cisco ACS v5.x Configuration.pdf