Below is an image that shows how to install a console cable into the FWSM's console port.
The console port is located on the FWSM board itself. Installing the console cable will require a removal of the FWSM from the chassis.
After the console cable is installed into the right most console port, push the FWSM back into the chassis. The console cable will squeeze between the blade and the module above it. The gasket will compresss and the console cable should come out the front of the FWSM just above the blade's faceplate.
FWSM console information:
Speed: 19,200 8 Data bits 1 stop bits No flow control or hardware handshake
I am attempting to setup a ASA 5515-x for the first time on my own.I have followed what I can on default cmd setup for the MGMT port.interface Management0/0 management-only nameif management security-level 100 ip address 192.168.1.1 25...
We are reviewing an ISE deployment.
ISE is trying to authenticate a user with a MAC address.
There is no DB server like Active Directory here.
Collecting the MAC addresses of numerous users is cumbersome.
Any good ideas?
We are trying to control devices through MAC authentication in ISE.
Endpoint Identity Group
ISE does not use user identity, onl...
I have an ASA where the Ciphers support is limited to 256 bit ciphers only. Why is it not showing 384 bit ciphers?Thanks in advance!-----------------ASA# show ssl ciphers all
These are the ciphers for the given cipher level; not all ciphers
are supported ...