The parameter -aN (where N is a number starting with zero or the string ALL) specifies the adapter ID. If you have only one controller it’s safe to use ALL instead of a specific ID, but you’re encouraged to use the ID for everything that makes changes to your RAID configuration.
Physical drive parameter -PhysDrv [E:S]
For commands that operate on one or more pysical drives, the -PhysDrv [E:S] parameter is used, where E is the enclosure device ID in which the drive resides and S the slot number (starting with zero). You can get the enclosure device ID using MegaCli -EncInfo -aALL. The E:S syntax is also used for specifying the physical drives when creating a new RAID virtual drive (see 5).
Virtual drive parameter -Lx
The parameter -Lx is used for specifying the virtual drive (where x is a number starting with zero or the string all).
The number N of the Array parameter is from the "Span Reference:" line you get using MegaCli -CfgDsply -aALL, minus the 0x0 part. For VSM systems it's normally 0. The number N of the row parameter is the Physical Disk in that span or array starting with zero (it can be but is not always the physical disk’s slot!).
Rebuild drive - Drive status should be "Firmware state: Rebuild"
Collect the MegaSAS.log, lsi-events.log, and the lsi-fwterm.log files from the directory where the commands are run (they can be run from any directory on the MSP server) and attach the logs to the service request. You may use a program such as WinSCP (freeware) to pull the files off of the server.
Hello,I set up a wired 802.1x configuration. A windows DC/DNS/CA and a DHCP/NPS server authenticate and authorize succesfully a switch port.Unfortunately, no traffic is allowed to pass through the port?!? IP address on the host and Vlan on the switch are ...
Hi Experts, Please check and suggest, if the attached design is a workable solution.Currently, working on migrating existing Apps to public cloud, since the customer dont want to change the public IP for the apps,resources, looking to forward the customer...
Trying to configure the FW to allow ssh from a remote vpn user to an inside private host over Mgt interface and allow traffic out Outside interfaceVPN is working correctly, ssh is not working to internal host in private subnet(traffic from the VPN subnet ...
I am having some issue attempting to get the Cisco AnyConnect app for iOS 13 to see certificates that are being installed via our MDM solution. If the certificate is installed via a VPN connection it shows in the AnyConnect app's certificates, but i...
I do some light sysadmin stuff for my wife's school and they had a BE4000 installed last year. The people who configured it didn't talk to the network people and configured it with static IP information. Well, our firewall changed and now it can't reach t...