Hi all,
i have configured BBSM in routed mode. I have a layer 3 switch behind the bbsm and it is configured with 2 vlans (1 for wired and 1 for wireless). The bbsm connects to the layer 3 switch through another vlan (I dont have dual vlan config) . I have configured the bbsm to see the layer 3 switch like a router.
1) Bbsm finds only 5 ports in every access point (AP1242G) instead of 30 ports, is it ok?
2) I have configured the switch that the access point is connected to, ip_addreess@200 . When i connect through the access point, bbsm understands that i am connecting through the switch port and not through the access point. I have also tried to configure the switch port which is connected to the access point as uplink port, but i get an error. Any help ?
3) In several switches i will use vlan 200 and vlan 400 too, but in the bbsm is possilbe to configured only one vlan per device. Does anyone has experience with this?
Thanks in advance.