This video explains the process of replacing a Cisco Email Security appliance that is part of a centralized management cluster.
Specifics covered include removing the failed appliance from the existing centralized management cluster. Saving and exporting the configuration file from the failed appliance using the GUI. Importing/loading the configuration file to the new replacement appliance using the GUI. Using the CLI to check the status of connectivity of the new appliance to the existing centralized managment cluster.
00:00--00:20 Intro and description
00:21--00:40 Pre-requisits, Requirements
00:41--00:58 Using the version command to verify version on both appliances
00:59--01:16 Using the "Clusterconfig" command and "removemachine" commands
01:17--01:36 Save and export the configuration file from old appliance/ensure removal
01:37--02:37 Using the GUI to Save the configuration file from the OLD appliance.
02:38--04:11 Loading/Restoring the config file on the replacement appliance.
0412:--05:02 Adding the new replacement appliance to the existing CMS Cluster
05:03--05:50 Using the connstatus command to verify cluster connectivity.
05:51---6:06 Closing
Notes: This video assumes that you have connectivity to the replacement applinace so that you may access the GUI.
Original Authors: Donny Lee (APAC)
Jerry Orona (SB-US)
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello
I have an Active/Passive setup on a couple of Firepower's and my ISP provider is pulling the rug out from underneath me and taking back their CIDR block. As a result, I have acquired a new ISP and have a new CIDR block.
Will the Firepower all...
view more
Hi,Would anyone know if it’s possible to download older versions of Cisco AnyConnect from Cisco directly? For example I’m looking for version 4.5.0.We have an SRX with an old firmware that can’t be upgraded, and there’s a known DHCP addressing bug w...
view more
Hello Experts,
I am using NX9K version 9.3(3), and I want to enable IGMP querier for L2 multicast, but I can't find the command,
please see the attached picture and kindly advise!
Regards
I have an ISE deployment with 2 PANs and 2 PSNs. Primary PAN, node A, had to be replaced due to hardware failure. node B was promoted temporarily so I can continue to manage ISE. I need to install the wildcard cert back on the new node A...
view more
We are preparing for the Software upgrade path for the FMC4500 and FP8360: Version 6.4.0.14 ->7.0.1.During the same maintenance window, we would like to install BIOS and Firmware Hotfix for FMC Hardware. Please advise if we meet the requirements for...
view more