This guide demonstrates the use of Model-Driven (MDT) Telemetry in the context of a virtualized Broadband-Network Gateway (vBNG). This lab aims to provide Systems Engineers with appropriate skills for creating environments that harness the streaming of telemetry data. It will enable them to understand and use MDT data of XR devices, a toolset with collection, storage, visualization and basic analytics, a data processing engine, and Cisco Network Service Orchestrator® (NSO). As such, the lab contains a brief overview of each component and a set of scenarios that help the engineer in defining the building blocks of a closed-loop telemetry environment.
Scenario 1: Build a Minimal BNG Setup
Scenario 2: Configure Telemetry Support for XRv 9000
Scenario 3: Automate IPv4 Address Pool Management
Xr9k Linux host at 198.18.134.28, as a KVM hypervisor for XRv 9000
XRv 9000 version 184.108.40.206I
XRv 9000 is accessible at 198.18.134.29 and through telnet 198.18.134.28 12787
Docker host at 198.18.134.27 with:
Docker stack of containers:
ANX Netconf Explorer
Simulator of DHCP clients
PC Workstation at 198.18.133.252 with Remote Desktop with Putty console for:
XRv 9000 DHCP server
Simulator for DHCP clients
MDT Closed-loop Telemetry
MDT streaming configuration
MDT collection with Cisco Pipeline
ANX Netconf Explorer for browsing MDT sensor-paths and generating Pipeline’s metrics file
Metrics monitoring in Grafana
Metrics data processing with the Kapacitor engine
NSO allows for DHCP pool definition and extension actions
Event-based automatic DHCP pool extension based on an increasing number of DHCP clients
We have basic IPoE service working on our ASR1002-X chassis, but cannot seem to assign a static IP address via RADIUS. Should I be using a different RADIUS attribute than Framed-IP-Address? A sanitized version of my configuration is below.&nbs...
HI friends , ping mpls pseudowire 10.10.10.10 1010 reply mode ? control-channel Send reply via a control channel ipv4 Send reply via IPv4 no-reply Send no reply router-alert Send reply via IPv4 UDP with router alert Could anyone explain the difference bet...
Hi there, I have two questions about licensing ASR9k, if someone can shed some light here on this matter. 1. When ordering ASR9k, is SIA software license a MUST for either FCM or Traditional model?1.1. If not, does the ASR9k get all the features...
Hi,thinking about upgrade from RSP440 to RSP880. Is it allowed, cisco supported hw configuration to use ASR 9010/9006 with SINGLE RSP880, relying to primary/secondary router redundancy only instead of additional inbox RSP redundancy?Any experience wi...