Effect of switch removal from the Fabric

[hassan_yousif2005]

What would be the effect of removing a switch from the fabric in DNAC ? will it perform normally if we discovered it and added it to the fabric again ?  What is the correct procedure to remove the switch from the fabric ? in my case I released all ports assignment -> removed the switch from fabric -> removed it from provisioning page then it disappeared from inventory .

The question is do we need to do any thing before we rediscover the switch and add it again to the fabric?

Thanks in advance

[ldanny · Accepted solution]

Hi Hassan,

The steps you have taken would be the correct procedure.

There is nothing else that needs to be done but just to run a discovery to get started.