Hey,What happens when a SMART license has expired or failed to verify for 1 year?I found this community post and the answer was just "Cisco is still having issues with their licensing and are not enforcing it"I found this Cisco blog post saying "At t...
In a scenario with two VNs. VN1 with IoT devices and VN2 with Clients. Both VNs contain multiple SGTs.I'm quite unsure about the "Best Practice" usecase regarding Fusion Routers and VNs in a Fabric. To my understanding each time I want to connect/rou...
I am having a problem trying to integrate ISE with DNAC for the first time.I am following this guide https://community.cisco.com/t5/networking-documents/how-to-cisco-dna-center-ise-integration/ta-p/3896410 and my question is regarding the shared secr...
Hi, In a four node ISE setup (two PSN, and two MnT), which of them do I connect to from DNAC for integration? Do I need to enable pxGrid on all nodes? What cert requirements are necessary on the ISE side? Thanks,daniel
Hello,Can someone confirm if 9600 is supported as seed device?
Hello All, I need to purchase new materials such as 9300 and 9500 catalyst platforms.I clearly need the functionnalities listed in the Network essentials for my access switch (9300 series) and Network Advantage for my distribution and core switches (...
Hi We are planning the backup strategy of DNAC (version 1.3.1.4) and ISE (version 2.6) for our SDA deployment. Could someone please suggest the following1. Maximum backup file size for DNAC and ISE (In the 1.0 documentation of DNAC at following URL ...
Hello Everyone, I have installed Embedded Wireless on catalyst 9300 switch, now I am trying to register the Access point (Model numbers : 3702 and 1852i) but I am unable to do the same as it is registering for a minute and trying to download the EWLC...
Hello All,I need your help to find out the root cause in my SDA topology configuration pushed via DNAC.I have a switch that acts as a border and control node and another switch which acts as an edge node. The issue I am facing that user networks not ...
Hello, I'm using Cisco DNA version System 1.2.0.1013 with Assurance version 1.3.1.140, about data Wired client , all informations are available under assurance>Health but for the Wireless client I don't have any information.The Wireless Controller...
I encountered a problem on DNAC. It reports connectivity to 10.30.5.131 is down. In fact, this IP address is my DNAC IP address. Secondly, in the system 360, I capture this screen for my DNAC. It said NodeStatusUnknown, Kubelet stopped posting node...
Hello, I have a design and best practice question. I'm working with a customer to help build out an SDA environment. With respect to SDA design recommendations and best practices, all clients should be DHCP-based leveraging address pools. However, ...
What would be the effect of removing a switch from the fabric in DNAC ? will it perform normally if we discovered it and added it to the fabric again ? What is the correct procedure to remove the switch from the fabric ? in my case I released all po...
Hi all: One of our customer is thinking to implement SDA into their network but still some doubts for IoT (OT) deployments due to multicast/broadcst traffic. Let me elaborate. These are the requirements from customer 1.- IOT PLC devices use b...
Hello,I have two catalyst 9500 planed to act as SDA border / Control plane nodes.My question can i connect some traditional legacy switches ( 2960x , 3650 ) and configure them using CLI traditional method ( L2 trunks ) on the same border nodes while ...
