Hi guys
We are suffering for provision issue of control / border node.
We have 2 C9407 as control/border node, over 100 C9300 as edge node. (most of edge is not managed as well ...)
This time, the problem is 1 of C9407 can't be provisioined.
(it was provisioned 5 month ago, but we couldn't get any trigger)
From TAC case, they suggested us to do factory reset and re-provision it.
So we are trying to figure out check points before do it
here some questions
1. do we need to wait for time after remove C9407 from the fabric??
I think control/border node is not like edge node. so worried that it takes long time or hanged ...
2. likewise do we need to wait for time after add C9407 to the fabric??
3. would you happend to know how long this will take ?
I wish to get some advice or your experiences
Thanks !
