Address Pool is not visible in Port Assignment DNA Center
I have couple address pools configured in DNA Center and correctly assigned to related VNs and all was good. Once when I tried to configure Multicast on particular network, DNA Center gave a "Provision Failed". After TAC case it was solved and now devices are provisioned correctly. The problem is, now, I dont see that particular pool in port assignments section. The devices, hold all information about that network and I can assign it manually from CLI but DNA center. I tried to re-sync devices but not result. Is there any way to fix this or I have to create another TAC?
Listen: https://smarturl.it/CCRS9E25 Follow us: twitter.com/ciscochampions
With applications and users everywhere, the networks are now, more than ever, being tasked with delivering consistent protection while providing an exceptional user exper...
Listen: https://smarturl.it/CCRS9E24 Follow us: https://twitter.com/CiscoChampion
Cisco Radio Aware Routing addresses several of the challenges faced when merging IP routing and radio communications in mobile networks, especially those exhibiti...
Listen: https://smarturl.it/CCRS9E23 Follow us: https://twitter.com/CiscoChampion The Wi-Fi 6E Catalyst 9136 access point takes advantage of the 6-GHz band to produce a network that is more reliable and secure, with higher throughput, more ...
When moving from OSPFv2 to OSPFv3, there are many changes in the format of the LSAs Type, but the most known changes are: IP prefix informations are no longer carried in Type-1 LSA and Type-2 LSA, new LSAs Type 8 and 9 are added to carry these prefixes.