5428 and MSA 1000

[kaned]

Im having an performance issue, if I use the HP PAT test im getting around 3 MBS - 6 MBS, im thinking i should be getting an higher throughput with this setup

Heres my setup and config

DL380 G2

I have all the latest firmware for the dl380 and have had HP verify the config and diag on the msa via array diag utility

EMULEX HBA

Cisco storage router

ive changed gbics and cables

ver 3.41-k9

config on 5428 is attached

Msa 1000

latest firmware verified by hp array diag verified by hp

If you have any suggestions id really apreciate your comments and or suggestions

also can anyone with a similar setup tell me what they are getting with the HP pat test

Thannk You

[#2]

Check if you are getting any errors on any of the interfaces. In some cases if there is a hardware problem with the interfaces the throughput comes down. Has the throughput ever crossed 3 Mb. If so was any changes done after which the throughput has dropped.