Cisco MDS 9148 and HP C7000

[UnitingCare]

Hi All,

Hoping someone can help me, I want to configure our C7000 with 2 x hp vc flexfabric 10gb/24-port modules to work with 2 x Cisco MDS 9148 switches but not sure what config I need to set on the 9148. 

So far I haven't been able to get this combo to work and not sure where to from here.

I've set the 9148 to nvp mode and set the ports to switchport mode f and when I plug our HP gear into it the HP gear can't talk to the Cisco switch.

Can someone please advise if I need to set NVP mode and if there's anything else I've missed?

Thanks

[Kirk J]

I'm not familiar with the HP gear.  Is the Flexfabric also in NPIV?  The MDS will likely need to have NPIV enabled.

Are you not getting links to come up at all, or just not passing traffic?

Thanks,

Kirk...