I am trying to connect a Qlogic switch to an upstream 9506. QLogic states that it supports a feature called transparent routing. I have done all the appropriate configuration, but the Qlogic does not see any remote devices from the Cisco switch. I have NPIV enabled on the 9500 and it sees the Qlogic as a host. Is there anything I need to do on the 9500 to push down it's members to the Qlogic switch?
In the previous article, we have seen, how to assign IP Address to Cisco UCS Management Interface. This way we gain access to the on-board management software called Cisco Integrated Management Controller (CIMC).
The next step of building UCS Server ...
How does everyone feel about service graphs in a brownfield network centric cutover? maybe I'm an old school engineer but I was taught that if you have to do a Pbr then your design is wrong. they are a pain to troubleshoot because you always f...
To participate in this event, please use the button to ask your questions
This special event - formerly known as Ask the Expert- is open only to Cisco Customers and Partners.
Many pages in the Cisco Community are acce...
Going to Cisco LIVE EMEAR 2020? Give your Data Center agenda a boost with these top recommended sessions. Register and join us!
Data Center Networking:
From Reactive to Proactive NetOps With Cisco Network Assurance and Insights- The Power of Data...