How to add zones to zoneset

[kendo.igor]

What is the command to add multiple zones to a zoneset?

[efrahim]

What platform you are looking for to add zones to zoneset.... MDS or SN series..

[kendo.igor]

Adding zones to zonesets on an MDS 9216.

[efrahim · Accepted solution]

There are few ways- sample of one of it is below

From the cli,

9509# conf t

9509(config)# zone name cisco vsan 1

9509(config-zone)# member ?

domain-id Add member based on domain-id,port-number

fcalias Add fcalias to zone

fcid Add FCID member to zone

fwwn Add Fabric Port WWN member to zone

interface Add member based on interface

pwwn Add Port WWN member to zone

symbolic-nodename Add Symbolic Node Name member to zone

9509(config-zone)# member pwwn 01:11:11:11:11:11:11:11

9509(config-zone)# exit

9509(config)# zone name cisco1 vsan 1

9509(config-zone)# exit

9509(config)# zoneset name test vsan 1

9509(config-zoneset)# member cisco

9509(config-zoneset)# member cisco1

9509(config-zoneset)# exit

9509(config)# exit

9509# sh zone

zone zoneset

9509# sh zoneset

zoneset name test vsan 1

zone name cisco vsan 1

pwwn 01:11:11:11:11:11:11:11

zone name cisco1 vsan 1

9509#

You can also use Fabric Manager to create and add zoneset. Also you have to activate the zoneseat to be effective...

Here is the URL for your ref..for software rel. 1.2.1

http://www.cisco.com/univercd/cc/td/doc/product/sn5000/mds9000/1_2/sw_confg/zonecnfg.htm#24151

Hope this helps..