OTU2-XP configuration inquiry

[Emyrsonn Rodil]

I have an OTU2-XP set as Transponder carrying 10GE traffic in ports 1&2...

I need a LAN PHY to WAN PHY application which can only run in ports 1&2. 

I plan to transfer the traffic in ports 1&2 to 3&4...

Will I need to delete all circuit provisioned in the OTU2-XP to modify its card configuration from "Transponder" to "10G Ethernet LAN Phy to WAN Phy"?

Thank you...

[Emyrsonn Rodil]

I was able to find a spare OTU2-XP ...

Now I need to configure it as 10GE LAN Phy to WAN Phy using ONS-XC-10G-S1=...

After provisioning the card configuration, what else do I need to do? 

Do I need to create a circuit for this requirement, LAN Phy to WAN Phy?

Thanks