Which material are Cisco 2802I access points made of?

[JoaoLucasMacedo]

Hello. We are running some validation assessments with 2802I access points for a clean environment, but we could not find any information regarding the material composition of these devices. Precisely its external cover.

Does anyone have a idea?

[Flavio Miranda · Accepted solution]

Hello

The plastic material used on the AP 2800 and AP 3800 series is Lexan 945. This material was tested for clean room use with a Steris chemical, trademark name SPOR-KLENZ. See http:/​/​www.sterislifesciences.com/​Products/​Surface-Disinfectants-Cleaners-and-Alcohols/​Sporicides-Sterilant/​Spor-Klenz-Ready-To-Use-Cold-Sterilant.aspx

https://content.cisco.com/chapter.sjs?uri=/searchable/chapter/content/en/us/td/docs/wireless/controller/technotes/8-3/b_cisco_aironet_series_2800_3800_access_point_deployment_guide/b_cisco_aironet_series_2800_3800_access_point_deployment_guide_chapte...

[JoaoLucasMacedo]

Thanks a lot Flavio. You get right the point!

[kennyfoster]

Hi,

I have a similar question about the type of polycarbonate plastic used with the Catalyst 9163E Outdoor Access Point? 

Is it the same type of plastic as used on the 2800, albeit a different colour, or different?

The reason I am asking is due to avoiding any plastic on our access points due to fire regulations. If I have the detail on the plastic then we can avoid the costs of burn testing and destroying multiple APs.

Thanks

Kenny

[MHM Cisco World]

https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-2800-series-access-points/datasheet-c78-736497.html

the data sheet have link to martial and WEEE compliance
you can talk look I think this answer your Q.