02-18-2016 07:57 AM
Hi,
I successfully installed VIRL but I am unable to enter in the VIRL VM address. Where do I change this after having already clicked 'Ok'?
In other words, I want to re-enter the ip-address:
Thank you,
Jonathan
06-02-2016 08:57 AM
Hi Jonathan,
Looks to me that your question was addressed in this thread -> Can't configure static IP with the virl.ini file or through ifconfig - Activation & Installation - Dev-Innovate discussi… .
If not please check this forum -> Virtual Internet Routing Lab (VIRL) - The Cisco Learning Network
Thanks,
Brett
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: