Hi,I'm trying to figure out the difference between MMD= and MMD++= on Cisco SFPs. Does anyone know what the ++ and = signify? What is the difference? Also, do you have any links to a document stating so? I've Googled everywhere and I can't seem t...
Hello,
I have tried copying an IOS image from USB to flash on a 3750X-48P-L Cisco switch. The switch had been part of a stack, lost power, and got caught in a boot loop.
I initialized the flash and I ran the following commands:
switch: di...
Hi,I successfully installed VIRL but I am unable to enter in the VIRL VM address. Where do I change this after having already clicked 'Ok'?In other words, I want to re-enter the ip-address:Thank you,Jonathan
Have you found anything within Cisco documentation explicitly saying ++ means TAA compliant? You provided a nice clue and unfortunately nothing official.
Thank you Carlos. I ran the boot usbflash0:xxxxx.bin command and I got the following results:
% Front-end Microcode IMG MGR: HW image is upgraded. MCU reset causes the switch to reload
Using driver version 1 for media type 2Base ethernet MAC Addres...