Your approach is fine and I believe it is feasible. However, performance and scaling would be dependent on the ESP. Below are some documents to help and configuration guides for reference -http://www.cisco.com/c/en/us/products/collateral/routers/asr-...
Hi Serge, Here is a good document to begin troubleshooting -http://www.cisco.com/c/en/us/support/docs/routers/asr-1000-series-aggregation-services-routers/110531-asr-packet-drop.html IpTtlExceeded increments when TTL exceedsIpv4Null0 packets that do ...
Hi, I would like to test this case. Can you share the following outputs, my e-mail id is vishever@cisco.com - show techshow ip bgp summaryshow ip bgp neighborsdebug ip bgpdebug ip nat detailedAnd the NAT Configuration that you apply on the router? -V...
Alex, Prefix-lists also have an implicit deny.How the System Filters Traffic by Prefix ListFiltering by prefix list involves matching the prefixes of routes with those listed in the prefix list. When there is a match, the route is used. More specific...
BFD has to at least establish the neighborship once, negotiate the timers etc. only after that it will begin the operation of fault detection. So you can configure it on one side without any concern. -Vishesh