Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We've successfully configured SCEP for Cisco AP 2800's. Flow is this: 1.SCEP uses CA1 for csr and EAP-TLS certificate - no issue2. Certificate used on Cisco ISE for mutual authentication for AP is signed by CA2 - need know how to install this Issue i...
We have configured SCEP for AP 2800's. The AP's have obtained the correct certificates and CA from CA-1.The AP's now try and authenticate to ISE via EAP-TLS on the wired switchport. The ISE certificate used for this authentication is signed by CA-2. ...
I've configured a CAM and CAS as both L2 OOB and have enabled L3 support with Real IP. I have a remote site that uses Avaya 4610SW VoIP phones. Both the CAM and CAS reside locally with no CAS at the remote site. I'm able to get full functionality wi...
Thanks Faisal. We configured the CAM to ignore the MAC addresses of the phone. The issue seems to be is that the CAM is not able to pick up the MAC address of the phone in the L3 OOB deployment. It only sees the MAC of the desktop, not the phone.When...
Hi Radoslav:Was there any resolution to this problem? I am running into the exact same problem however I'm using NAC Appliance 4.1.6 and cat4500-ipbasek9-mz.122-31.SGA8.bin.
