Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently use local accounts with this format:username test password testpwd role network-adminand this puts you straight into 'enable' modeI am trying to get this to work with tacacs and having a few problems. I am able to get the authentication t...
yeah I later found the command:aaa authorization config-commands default group AAA-Serversbut was unsure if it would make the difference I was needing and I did not find it untill after I had already removed the config.
i was able to run the collection and they all failed with one of the 3 reasons listed below.-Device sensed, but collection failed -Transport session to device failed. Cause: Authentication failed on device. -Device Collection Failed
when I go to: RME -> Devices -> Inventory -> Inventory Jobs -> it sends me to this URL:http://X.X.X.X:1741/rme/ICSJobBrowser.dobut the page never loads.
What error message (if any) do you get when you try to collect their inventory?I am new to 2.5.1 and I do not see how to do this. I am also looking for Check Device Attributes.
I have AP350's and AP1200's...RFC1213-MIB::sysDescr.0 = STRING: "Cisco Internetwork Operating System Software ..IOS (tm) C350 Software (C350-K9W7-M), Version 12.2(13)JA1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)..TAC Support: http://www.cisco.com/tac....
