About LaurentRA

LaurentRA · 03-03-2020

Hello community, I had an issue on a customer site with a ring topology using REP where one port was in Fail state.Physically (layer2) the port was fine.But when I looked at REP status for that switch in Fail, the link is ok in Two Way state but the ...

LaurentRA · 03-04-2020

Yes for the moment that's what I will do, Upgrade.

LaurentRA · 03-03-2020

The best details I can found so fare are from the following technical support even if the drawings are difficult to read. Resilient Ethernet Protocol Overview

LaurentRA · 03-03-2020

Hello, thanks for the replyThe failed port stayed in that state (Failed with wrong key) for days from what the site operators told me. I do not know what was the cause.Shutting down the port and Up again did not allow to clear the previous wrong lear...

LaurentRA · 03-03-2020

Hello, If I am not mistaking, you have configured the layer 3 part of the Vlans (with command (config)# interface vlan x and give an IP address) but you have not declared the Vlans at Layer 2 level (command (config)# vlan x). I would suggest first to...

Member Since	‎02-12-2020 09:26 AM
Date Last Visited	‎02-19-2021 12:32 AM
Posts	5

User Statistics

User Activity

REP shared alternate port key process ?

Re: REP shared alternate port key process ?

Re: REP shared alternate port key process ?

Re: REP shared alternate port key process ?

Re: Newbie trying to get 2 switches to talk to each other