Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question regarding the 3925 router. In the past on my old 3660's, in order to add a new line to an ACL, I would have to remove the entire ACL and readd it when adding new ACL lines to the list. Is this required on the 3925's, or is it like t...
Hello, I will preface this discussion by saying that I'm not sure if this is even possible. On my 5520 I am trying to use one NAT to route all inbound traffic to one private ip (SMTP) and using the same NAT point all outbound traffic from another ...
Hello, Trying to add the following from a SAN-OS fabric switch to a NX-OS switch:aaa new-modelaaa authentication login default group tacacs+ localaaa authentication enable default group tacacs+ enableaaa authentication ppp default localaaa authoriza...
Hello, I was in the process of creating a AAA setup on my NX-0S (MDS9148), logged out/attempted to login to test AAA login and now I can no longer login as admin either! I didn't change the local account. I have the Cisco Device Manager open still ...
