Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I want to do a "HA-Active/Standby" configuration of two ASAvs and then do "Remote Access - IPsec".Do I need to configure the "HA-Active/Standby" then IPsec.Or configure the "Remote Access - IPsec" then the "HA-Active/Standby".Thank you in advan...
Hello,I have a failover configuration - Active/Passive.On this configuration, I have set the "remote access - vpn IPSec" on the primary and I have recorded on the secondary (the recording is done automatically as soon as you enter "write memory" on t...
Hello,I am trying to connect from a workstation (RDP) to an "ASAv" via IPSec VPN.The VPN stops at the end of its establishment.I have error messages.Ayconnect :Ready to connect.
Contacting ASA(IPsec) IPv4.
User credentials entered.
Establishing VPN s...
Hello, I have a Cisco ASA, HA - Active/Standby (ASA1 and ASA2) configuration:ASA1: Gigabit 0/0 (Management) - 192.168.1.110,ASA2: Gigabit 0/0 (Management) - 192.168.1.111.Is it possible to keep the Giga 0/0 management interface of the secondary ASA ...
Hello, I have a Cisco ASA configuration : HA- Active/Standby.As soon as I set up standby, I lose the ssh connection. This is because the management interface is overwritten by the synchronization of the configuration with the 'Active'.Can you help me...
Hello,Everything is going normally as planned.That is to say that during the switchover, the user's session remains active. But it is the xml file which disappears. Here is the configuration. ASA-1/pri/act# show running-config
...
no mac-address auto...
Hello,Thank you for your reply.Here is the configuration made in the 'ASA'.ASA-1# show running-config
: Saved
.....
ip local pool raIPSecPool 192.168.1.2-192.168.1.22 mask 255.255.255.0
!
interface GigabitEthernet0/0
nameif INSIDE
security-level...
Hello,Yes, failover works. It's just a problem that I can no longer access the ASA after the failover. I used « tracert » to check the path, all the intermediaries are responding, just the ASAs are not responding. I've restarted my computer and waite...
Hello,I'm in a lab (vSphre), I need to test and be sure it works before I deploy. That's why I'd like to see the failover test.The INSIDE and OUTSIDE interfaces are not connected but they are in the same VLANs.At first I have access to both ASAs (ASA...
Hello, I have all the interfcaes supervised.When I do 'shutdown' on giga 0/1 (ASA-1 , Outside), the two interfaces ASA1 (giga 0/1) and ASA2 (giga0 / 1) become down. No failover.When I do "no failover active" on ASA-1, I stay for a few seconds and the...
