Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Team, I have device FPR 4110. Running 6.1.0.330.cfp Type FTD (if using GUI) but when I SSH device. show version : System version: 4.0(1.140) and FMC running on 6.2.2 as below.. my question is,How to upgrade version FTD(Device) and FMC ...
Hi Team, I cannot config or update policy with FMC (FTD FPR4100). When i update policy and want to save and deploy, this error show " deployment failed due to connectivity issues with the device or device is not responding. if problem persists after ...
HI Team,Currently I using Firepower 4110 ver6.2.2.. GUI i can access.But when using SSH, it auto enter to expert mode. Why I can't exit expert mode.? Connection established.
To escape to local shell, press 'Ctrl+Alt+]'.
WARNING! The remote SSH serve...
Hi,Tried to follow the guide line, but i cannot type anything.. Cannot type flash_init . press enter also cannot..Step 2.Initialize the flash file system with the command: flash_init
Hi Rob Ingram, Thanks for reply.. FTD System version: 4.0(1.140)FMC Operating System Version 6.2.2 You meant doing ssh FTD use the command "capture-traffic" ? I don't see this command at CLI FTD. last time I reset FTD and connect back to FMC, and i...
Dear All, Timezone at FMC is correct when i configure System>Configuration>Time Synch.But when i go to device>device management > Device. it show wrong timezone UTC (UTC+0:00). And i go to Platform setting>Time Synchronization set my clock Via NTP fr...
