Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone;We are facing a strange issue on the model 2700 with 9800 WLCDesign = Branches are setup as flex connect APs, WLC is located in Datacenter and the connectivity between Branch and DC is sdwan. For some reason AP 2700 are restarting sporad...
Hey everyone, Is it possilbe to send the interface description, which the client is connected on wired, to ISE?If so, how can you set this up? for example:interface GigabitEthernet6/0/37description Video port 1GE UTP INTERFACE I want to send "Video p...
Hi all, I would like to know if Cisco has the same feature like Juniper Mist. We would like to broadcast one SSID, but that SSID has multiple psk configured with. Based on the PSK, the client will be put in a specific vlan. The ISE authentication pol...
Seems indeed to be similar, because the other AP models does not experience the same problem even though they are connected on the same switch, using the same priority, same gateway,...Unless there must be a feature enabled for those 2700-2800 models...
Hi, This could work as well! Workaround:12.2(43)SE2 and above (MAB only), VLAN ID can be added to NAS-ID attributeSwitch(config)#mab request format attribute 32 vlan access-vlan15.2(2)E/3.6.0E/15.2(1)SY and above (Using IBNS 2.0 syntax), VLAN ID and ...
Hi , Thanks for responding first of all! I know, but maybe I did not explain my purpose What we want to reach is:For every device that is managed by R&D department (We as IT departement do not care for them at all), we would like to match them on t...
Hey Thomas, We are implementing Cisco ISE dot1x solution for all our (+80) Cisco Campus switches. We would like to have two default container vlans, if nothing could be matched on the previous conditions:Option 1=> Engineering (can be any device with...
