Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am, implemented the network automation by integrating the openstack with the Cisco ACI.
(ACI Firmware 2.3(1e), Openstack Newton)
I used it without any problems.we also used ACI's visibility&troubleshooting capabilities well.
(See Attachment)
...
hi
The N93180YC is currently being used as an ACI leaf switch.
I want to change N93180YC to NX-OS.
Please tell us the procedure to change it.
If you have a URL, please let us know the URL.
Thank you.
When i plugin ACI and Openstack, have confirmed that there is "GBP, ML2 Driver".
What is the difference between "Group-Based Policy and APIC ML2 Driver"?
What does "OpFlex" mean when I mention "Deploying OpFlex ML2 and GBP" in the manual?
What areas ...
When specifying a device type, do I have to specify it exactly?
For example, if I connect to an open stack or VMware, can I specify it as bare metal instead of ESXi?
If it is possible or impossible to specify, I would like to know more about the dif...
If I set "edge" without setting "edge trunk" on the trunk port, will not it be fast convergence?
What happens to the spanning tree or link if I change the "edge" configured port to "edge trunk"? (Is there a problem?)
must, do I have to set the "edge"...
admin@apic1:aci> reloadCtrl-Cloader>boot usb#:nxos-image-name
Is there a problem if I do not partition?
Can I boot to nxos by changing the boot path to USB as in the above procedure?
And there is no "copy" command in loder mode.
loader > dir usb2:
...
What exactly does Step 3, 5 mean in the document?
Is it a procedure that must be done?
And I think you'll need to upload NX-OS before boot in step 4.
What steps should NX-OS upload and upload be possible via USB?
Do I need to upload NX-OS files in a...
