Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
On Cisco C1161 running IOS XE 26.01.1, enabling global "mdns-sd gateway" immediately triggers "%MDNSPROXY-3-PORT_RESERVED_MDNS: IO Initialisation failure".The same error occurs with legacy "service-routing mdns-sd". The error disappears after removin...
I implemented a remote network using DMVPN. The routers at both ends are C1111 and C1161, running the latest iOS 26.1 system. Both networks are connected to multiple access points, running ME 8.10.196.0, with mDNS and mDNS snopping enabled. Both netw...
Cisco posted this issue and solutions at:https://www.cisco.com/c/en/us/support/docs/field-notices/722/fn72209.htmlUnfortunately, the c1161 router I purchased is in the VID and version range that Cisco listed above:MIDPLANE EEPROM data:
EEPROM versi...
Deployed Mobility Express version 8.10.196 on 3 1815w APs, the router is c1161-8w, PPPOE is enable with SLAAC. All intranet devices get their IPV6 address.But I notice that all the APs do not have IPV6 address (despite all the Chinese characters due ...
在cisco c1161-8p路由上配置了IPSec及EOGRP的dmvpn，隧道网段10.0.0.0，本地网段192.168.0.1，dialer1接口上有固定公网ip。使用EIGRP动态路由，取消水平分割并优化下一跳配置如下：tunnel0配置：interface Tunnel0ip address 10.0.0.1 255.255.255.0no ip redirectsip mtu 1400no ip next-hop-self eigrp 100no ip split-horizon ...
I did some test, on ME side the mDNS got no problem. mDNS server can be found by ME.Issue happens on C1161 router, once I configuredconf t
!
mdns-sd gateway
!
endthere will be a err log*May 30 14:11:10.447: %MDNSPROXY-3-PORT_RESERVED_MDNS: IO Initial...
Thank you for your answer. I apologize that I didn't fully describe the problem scenario clearly at the beginning. Your description of the network topology is completely correct.The problem I'm encountering is on one side, like Multiple APS----(ME)IS...
Hi Rockyw，Thank you for detailed explanation on this "workaround solution". And it will be helpful for all the others who encounter the same issue.Sampson
I got a c1161-8pltep from vendor to replace this c11161 on Oct 1st, it works fine till today with the original power supplyand its pid and deviation are:MIDPLANE EEPROM data:
EEPROM version : 4
Compatible Type : 0xFF
Chassis MA...
Hi Leo:Is this for testing? or you are sure it is really a power supply issue?Other devices in deck with same power supply does have no problemAnd...I do not have UPS
