Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The wifi has been working fine for a few months or so now but all of a sudden alot of our users are having issues connecting to our internal and guest networks. I have tried on apple devices as well as android devices but they both keep erroring ut s...
IS there a way to upgrade the ios on a cisco 9200l switch using a usb drive instead of using a tftp server? If so could someone point me to the article or tell me how this can be done? These switches seem to be more complicated than previous switches...
I wish I could find some setup instructions for these. The rath company shows how to change the IP but when iut comes to connecting it to your CM they say contact cisco. We just got two of these and I'm trying to figure out how to connect and registe...
In my setup, the issue was that my password had changed that was being used to authenticate users with our AD server. I hadn't updated the password in the dashboard that Meraki uses to verify/authenticate with our server.
Got it figured out a while back, just forgot to update sorry. I was able to boot the switch using the drive and copy the file over at that point. Planning on going Meraki one day so I wont have to do this again.
I should be able to copy as you said but it doesn't work as I said before. I've tried the copy mode mentioned from Rommon mode and from switch# mode as well with no working results as of yet. As far as the link goes, he set his up to boot from a tftp...
After trying the commands with both usb ports I get the same result if I try to copy the file to flash. Flash is read only. switch: copy usbflash1:/cat9k_lite_iosxe.16.12.03.SPA.bin flash:Unsupported destination device/filesystem.
