Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
We have a a 5512-X with the 6-port expansion card installed. Our network requires that 6 hosts be connected on the inside ports and 6 hosts connected on the outside ports pass multicast traffic. The 6 hosts on the outside are receiving ...
Hello all,
We have a Cisco 2951 Router that has 2 EHWIC-1GE-SFP-CU cards installed and 1 24 port switch module. On the 24 port switch module we have several VLAN's and interface VLAN's routing the data between them. The question we have is whether...
We want hosts on Vlan XX located on the switch module to be able to communicate with another switch outside the router that hosts the same VLAN. It used to be just 2 switch but management in their infinite wisdom purchased the router. The current s...
Thanks for the response. I have the IP address setup between the router and the embedded switch so that I can ssh and such between them . I have tried setting the 0/25 port on the switch module as a trunk and at the EHWIC there is not an option to ...
