About martinh1

martinh1 · 02-28-2023

Hello everyone,we've recently come across an issue where a phone is plugged into a Port-Security free port on a C2960CX (supplicant_A) ('dynamic' according to the Mac Table). If this phone is plugged into a second C2960CX (supplicant_B) (port also wi...

martinh1 · 02-28-2023

I tried the inactivity timer, no improvement.Just to be clear, the phone never appears as a session. All sessions I have on this interface is the C2960CX uplink port. The mac address is stuck in mac table. That's why I thought 'multi-auth' could help...

martinh1 · 02-28-2023

This command is already in our standard configuration and is active on all switches.We have also tried to apply 'host-mode multi-auth' instead of 'multi-host' on the interfaces and various 'clear'-commands in privileged mode... None of this helped.

martinh1 · 02-28-2023

changed the timer to 1, still no improvement.In a later step, the telephone ports will be provided with dot1x, but they have to load their initial configuration/firmware out-of-the-box. This only works on a free port, even on port security ports they...

martinh1 · 02-28-2023

I sent the command to both ports from the authenticator and plugged the phone out and back in, unfortunately the result remains the same.Port-Config looks like this now:interface GigabitEthernet2/0/12 description supplicant_A switchport mode trunk lo...

Member Since	‎03-27-2020 12:54 AM
Date Last Visited	‎05-15-2023 11:33 PM
Posts	5

User Statistics

User Activity

Problem with clearing a static mac address on neat port

Re: Problem with clearing a static mac address on neat port

Re: Problem with clearing a static mac address on neat port

Re: Problem with clearing a static mac address on neat port

Re: Problem with clearing a static mac address on neat port