Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had an AP a while back just stop working and started giving this constant loop of CAPWAP errors. We tried to do a factory reset by unplugging, holding the MODE button, and reconnecting power while holding the button until the light turned. This di...
I can't seem to get in rommon. I have been using the same usb to rj45 cable since the beginning, but every since I flashed that image when I try to send a break signal; I looked up all the break signal keyboard combinations on cisco just to try other...
That's what I figured the issue was, but I can't seem to get into ROMMON now. When the image is inflating I hit Esc and nothing happens. I have also tried TeraTerm (Alt-B) and several other keyboard shortcuts I found in cisco forums, none of them wil...
No I initially labeled this as 2600 series but as you can tell from the config it’s a 3600. I went to Cisco’s website and downloaded the image for the air-cap3602i-a-k9. That was ap3g2-k9w8-mx.153-3.JF12.tar
Okay sorry i was off work for a few days. I got the image put on the AP (I did have to use the ether_init command), but now when booting it says that "Radio FW image download failed ... Could this be that the image was the wrong one or does this soun...
