Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ASA Version 8.2(5)Device Manger Version 6.4(5)So I'm trying to setup port forwarding for a single camera with an ip address and its using port 80 to stream the video feed. I think I have most of it setup however when I get to the nat command it keeps...
We have had this Cisco ASA 5505 Firewall for about 5 years now and no issues until now. This particular computer is not new however, we recently moved it from a remote site (that is connected to our network) to here at the office. Now this firewall w...
This code was at least accepted. If the internal ip address changed how would I make that change in ASA? Still trying to gain access through the modem and firewall so I can't quiet accept this as an answer just yet.
Would this be possible if I just created this network object last week? By that I mean in the last 6 years of owning this device I have been the only to program it and I know I have never used that as a network object.
This gives me an error on the host commandASA# config tASA(config)#ASA(config)# object network ASA-CameraASA(config-network)# host 10.10.2.150 ERROR: Invalid hostname: '10.10.2.150' INFO: A hostname must start and end with a letter or digit, and have...
So I disconnected the network from the ASA 5505, power cycled everything and then used the link below to reset my network settings and now I'm connected. I don't know what went wrong or where but the point is I'm up and running again. Thank everyone ...
