I have a sg300-52 in layer 3 mode. I have 2 Dell access switches that connect to the sg300 in 4 port LAGs each. Connectivity works as expected.Servers are on their own VLAN, and plugged directly into the sg300. When somebody starts a file copy fr...
I am having an issue with setting a port in access mode and assigning it to a vlan.I have a 300 series switch in layer 3 mode that is handling intervlan routing.I also have a cisco 2651xm WAN router that handles the routing for the voice vlan.Everyth...
model: SG300-52version: 1.1.0.73Switch is running in layer 3 mode.How can I turn off mDNS broadcast coming from the vlan interface on the switch.Getting mDNS broadcast from switch every 5 seconds.-Matt
Try upgrading to 1.1.2.x firmware. It fixes: "Some MAC addresses are not showing (relearned) after a period of 4 to 6 weeks in the switch table. Cisco0000263 (FDB cache timestamp wraparound issue)"Which if the switch cannot relearn a MAC address sou...
Another thing that I did notice last night. I have Link Aggregation setup between the sg300 and some dell gigabit access switches. When I noticed latency and bandwidth degradation it was first to a specific server connected to the sg300. I was doi...
This just happend to my sg300-52. Network bandwidth went to crap. I decided to reboot the switch before searching about it. The switch had a runtime of 52 days. After reboot everything back to normal.It is running in L3 mode. It was running 1.1....
Thanks for your reply Dave. I figured it out. To make a long story shorter. I have a Cisco 2651XM on site that does the routing for my MPLS. I added the new VLAN subnets into the VRF table. This 2651XM use to be the default gateway before the SG...